Sed Udomboonyanupap, Somsak Siwadamrongpong, Apiwat Muttamara, and Thongchai Pangjundee

DOI: 10.14456/sjst-psu.2020.89

pp. 705 - 713

Abstract

The Taguchi method and regression analysis were used to evaluate the machinability of aluminum A356 with
conventional and ultrasonic-assisted milling. Experiments were carried out based on an orthogonal array L₁₈ with three
parameters (milling condition, spindle speed, and feed rate). According to the signal to noise ratio (S/N), the optimal surface
roughness condition was determined at A1B3C1 (i.e., milling condition was conventional milling, spindle speed was 7000 rpm,
and feed rate was 50 m/min). The optimal surface hardness condition was found at A2B1C3 (i.e., milling condition was
ultrasonic-assisted milling, spindle speed was 3000 rpm, and feed rate was 400 m/min). Analysis of variance (ANOVA) was used
to determine the effects of the machining parameters which showed that the feed rate was the main factor affecting surface
roughness and microhardness. Linear and quadratic regression analyses were applied to predict the outcomes of the experiment.
The predicted and measured values of surface hardness were close to each other while a large error was observed for the surface
roughness prediction. Confirmation test results showed that the Taguchi method was successful in optimizing the machining
parameters for minimum surface roughness and maximum microhardness in the milling of aluminum A365.